fischertechnik ROBO RF DATA LINK Manual De Instrucciones página 46

ROBO RF DATA LINK
This device complies with Part 15 of the FCC Rules and with RSS−210 of Industry Canada.
Operation is subject to the following two conditions:
(1) this device my not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
Warning: Changes or modifications made to this equipment not expressly approved by fischertechnik may void the FCC
authorization to operate this equipment.
The radiated output power of RF−Data−Link is far below the FCC radio frequency exposure limits. Nevertheless, the RF−
Data−Link shall be used in such a manner that the potential for human contact during normal operation is minimized.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guaran-
tee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
¯ Reorient or relocate the receiving antenna.
¯ Increase the separation between the equipment and receiver.
¯ Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
¯ Consult the dealer or an experienced radio/TV technician for help.