High Torque Micromotor Module With Fibre Optic; Micromotor Module For Implantology; Powder Cleaner Module - eurodent Iso Plus Manual Del Usuario

HIGH TORQUE MICROMOTOR MODULE WITH FIBRE OPTIC

MICROMOTOR MODULE FOR IMPLANTOLOGY

3 2 1

POWDER CLEANER MODULE

46
If the max. programmable power is set between 11% and 100%, the
module operates just as the MICROMOTOR MODULE WITH FIBRE
OPTIC.
If the max. programmable power is set between 01% and 10%, the
high torque/slow speed operation mode gets automatically selected.
To obtain best results when operating at slow speed, it is
advisable to make use of reducing handpieces.
It operates as the Micromotor, if the maximum power is set
between 11% and 100%. If the maximum power is set
between 01% and 10% the slow-speed operation with high
torque is automatically selected.
Spray can be obtained in two ways:
a function (position I): the external spray source supplies
I
only liquid. Make use of the potentiometer under the
module to adjust the spray flow rate.
II a function (position 0): spray comes from the unit circuit.
1 Spray setting switch
2 External spray adjustment (position I)
3 Internal spray adjustment (position 0).
To obtain best results when operating at slow
speed, it is advisable to make use of reducing
handpieces.
When picking the handpiece up, spray, automatic c.b. and c.b. light
their pilot leds up.
For the handpiece hygiene, use a cold sterilizing liquid.
MODULES
MODULES
MODULES