Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
TOP PANEL FEATURES
1.
POWER LED – Illuminates
when the mixer is on.
2.
MIC GAIN – Adjusts the audio
level of the microphone signal.
3.
MIC BASS – Adjusts the low
(bass)
frequencies
microphone channel.
4.
MIC TREBLE – Adjusts the
high (treble) frequencies of the
microphone channel.
Tip:
If
you
feedback
when
microphone at loud levels, try
turning
down
frequencies.
5.
CHANNEL GAIN – Adjusts the
corresponding channel's pre-
fader and pre-EQ gain level.
6.
CHANNEL TREBLE – Adjusts
the high (treble) frequencies of
the corresponding channel.
7.
CHANNEL MID – Adjusts the
mid-range frequencies of the
corresponding channel.
8.
CHANNEL BASS – Adjusts
the low (bass) frequencies of
the corresponding channel.
9.
INPUT SELECTOR – Selects
the input source to be routed
to the corresponding channel.
Input jacks are located on the
rear panel.
10.
CHANNEL FADER – Adjusts
the
audio
level
corresponding channel.
11.
HEADPHONE VOLUME – Adjusts the volume level of the headphone output.
12.
HEADPHONES – Connect your ¼" headphones to this output for cueing and mix monitoring. Headphone
output controls are located on the top panel.
13.
CUE SLIDER – Previews the audio playing on Channels 1 and 2. Sliding this to the left plays Channel 1.
Sliding to the right plays Channel 2.
14.
CUE METER – Monitors the pre-fader audio level of Channels 1 and 2.
15.
CUE MODE SELECTOR – Selects the audio that is sent to the headphones. Switch it to "MASTER" to hear
the Program mix. Switch it to "CH1 CH2" to hear Channels 1 and 2 in the Cue channel. (See #13).
16.
CROSSFADER – Blends audio playing between Channels 1 and 2. Sliding this to the left plays Channel 1 and
sliding to the right plays Channel 2.
Note: The crossfader is user-replaceable if it should ever wear out. Simply remove the facepanel, then remove
the screws holding it in position. Replace the fader with a quality authorized replacement from your local
Numark retailer only.
17.
CROSSFADER (CF) MODE – Reverses the assignment of Channels 1 and 2 on the crossfader.
18.
CROSSFADER (CF) SLOPE – Adjusts the slope of the crossfader curve. Flip switch to the left for a smooth
fade (mixing) or to the right for a sharp cut (scratching).
19.
MASTER – Adjusts the output volume of the Program mix.
20.
STEREO LEVEL INDICATOR – Monitors the audio level of the Program mix.
21.
SUB BASS – Adjusts the level of sub-harmonic (bass) frequencies of the Program mix.
of
the
experience
using
a
the
high
on
the
21
5
4
6
3
20
2
7
14
8
17
9
18
10
16
6
5
19
1
6
15
20
11
7
13
8
9
10
12
Publicidad
Tabla de contenido
