Before Using For The First Time - Krups SAVOY Manual De Instrucciones

BEFORE USING FOR THE FIRST TIME

„ „
Remove all of the various packaging, stickers or accessories from both the inside
and outside of the kettle (do not forget to remove the transparent protective film from
the screen).
„ „
Adjust the length of the cord by winding it under the base. Wedge the cord into the
notch. (fig. 1)
„ „
Before first use, rinse your kettle. Boil water at maximum capacity 2 or 3 times.
Throw away the water.
1. TO OPEN THE LID.
„ „
Press the opening button on the lid. It lifts automatically. (fig. 2 and 3)
To close, press down firmly on the lid (fig 6).
2. PLACE THE BASE ON A FLAT, STABLE, HEAT-RESISTANT SURFACE AWAY
FROM WATER SPLASHES AND ANY SOURCES OF HEAT.
„ „
Kettle is only to be used with the base provided.
3. FILL THE KETTLE WITH THE DESIRED AMOUNT OF WATER. (fig 4)
„ „
Never fill the kettle when it is on its base.
„ „
Do not fill it above the maximum level, or below the minimum level. If the kettle is too
full, boiling water may spill out (fig 5).
„ „
Do not use without water.
„ „
Check that the lid is closed properly before use.
4. POSITION THE KETTLE ON ITS BASE. PLUG IT INTO THE OUTLET.
5. TO START THE KETTLE
Press the on/off button on the base ON/OFF (fig 7).
The temperature of the water in the kettle is displayed on the screen.
TO BOIL THE WATER
2 options:
–
„
If you would like to boil the kettle, press the BOIL button (fig 8).
–
„
If you would like to choose your own temperature (7 options: 212°F - 200° F -
195°F - 185°F - 175°F - 155°F - 140°F), press the TEMP button until you reach
the desired temperature (fig 9).
„ „
Once the temperature has been chosen, the boiling cycle will begin automatically
after 2 seconds, and will stop once the selected temperature has been reached
(accurate to +/- 6°F).
„ „
To stop the cycle once it is under way, press the selected button once again (either
the BOIL or TEMP button).
4
USE