geberit AquaClean 8000plus Instructions De Montage página 10

EN
Start-up installation
Initiation programme
An automatic initiation programme is run before
inserting or filling the active carbon filter and nozzle
cleaning agent. Duration of the programme 2–9
minutes.
Start operation of the toilet
1
Fit the spray shield.
2
Open the maintenance opening.
1
3
Press and hold the main button (1) while
switching on the main switch (2). Wait until
the dryer arm is extended and the blue LED
flashes. Initiation programme starts.
1
2
The initiation programme is active as long as
the blue LED flashes. If a fault occurs, the
programme is cancelled after 9 minutes and
the red LED flashes.
If the red LED flashes, the fault (e.g. lack of
water) must be rectified and the initiation
programme must be restarted.
10
1
2
2
4
Insert the active carbon filter.
5
Remove the screw cap of the nozzle
cleaning agent and pull out the filling tray on
the toilet. Lift the bottle and turn it around.
The nozzle cleaning agent automatically
flows into the tank. Do not squeeze the
bottle, as the nozzle cleaning agent could
spray outside the tank.
1
3
2
6
Reinsert the filling tray and close the
maintenance opening.
If active carbon filter and nozzle cleaning
agent are not used/topped up, the red LED
will light up.
7
Cover the window of the user detection with
your hand and keep it covered.
8
Check if the <Air purifier> and <Dryer>
buttons are pressed on the control panel. If
not, press both buttons. Air purifier starts.
B822-004 © 10-2012
997.181.00.0 (02)