Hilti ST 1800-A22 Manual De Instrucciones Original página 11

5 Operation
Inserting the battery
WARNING
Risk of injury! Inadvertent starting of the impact screwdriver.
▶ Before fitting the battery, check that the cordless impact screwdriver is switched off
and that the forward/reverse switch is in the middle position (i.e. safety lock engaged).
WARNING
Electrical hazards! Risk of short circuiting.
▶ Before inserting the battery, check to ensure that the battery terminals and the contacts
in the impact screwdriver are free from foreign objects.
WARNING
Risk of injury! Hazard presented by a falling battery.
▶ A falling battery may present a risk of injury to yourself and others. Check that the
battery is securely seated in the power tool.
Note
Make sure that the outer surfaces of the battery are clean and dry before inserting the
battery in an approved battery charger.
Fitting / removing the depth gauge (optional)
Note
When driving screws with a sealing washer, use a depth gauge suitable for the diameter
of the sealing washer (accessory). When the depth gauge is correctly adjusted the screw
seal will be correctly compressed.
The depth gauge is attached to the metal construction screwdriver by way of a snap-on
connection and can be simply pulled off or pushed on.
Setting the depth gage (accessory)
Using the protective cap
Note
When the depth gauge is not fitted, the guard protects the depth gauge holder from dirt
and damage.
Fitting / removing the accessory tool
CAUTION
Risk of injury. The accessory tool may be hot or have sharp edges.
▶ Wear protective gloves when using the power tool and when changing accessory tools.
Note
After fitting the drill bit, grip it and pull it in order to check that it is securely engaged.
Fitting / removing the screw guide (optional)
Note
Use of the Hilti ST-SG 5.5/6.5 screw guide is recommended for sandwich panel screws.
Setting forward or reverse rotation
Note
An interlock prevents switching while the motor is running.
The control switch is locked when the forward/reverse switch is in the middle position
(safety lock).
Setting the torque
Safe operation
WARNING
Electric shock A fastener coming into contact with a concealed electric cable may result
in electric shock.
▶ Never use the depth gauge or chuck as a gripping area.
Note
Always hold the tool by the grip and/or with the hands on plastic parts of the casing (in-
line grip).
Printed: 27.07.2016 | Doc-Nr: PUB / 5293039 / 000 / 00
2
3
4
5
6
7
8
9
10
5