Intended Use; Items Supplied; Li­ion Battery Display; Cordless Metal Screwdriver - Hilti ST 1800-A22 Manual De Instrucciones Original

Torque adjustment
)
Chuck
+
Protective cap
§

3.2 Intended use

The product described is a hand-held cordless screwdriver for fastening profile metal sheets, metal sheets
and sandwich panels in metal construction. The product is designed for driving and removing self-drilling
and self-tapping screws in appropriate materials and material thicknesses.
It is possible to use a stand-up tool for driving collated screws.
▶ Use only Hilti Li­ion batteries from the B 18 / B 22 series with this product.
▶ Use only Hilti battery chargers of the C4/36 series with these batteries.

3.3 Items supplied

Metal construction screwdriver, ST­DG 19 depth gauge, ST­DC protective cap, S­NSD 8 screwdriving bit,
operating instructions.
Note
Spare parts, consumables and accessories approved by Hilti for use with the product can be found at
your local Hilti Center or online at: www.hilti.com
3.4 Li­ion battery display
The charge status of the Li-ion battery and malfunctions of the power tool are indicated by the display on
the Li­ion battery. The charge status of the Li­ion battery is displayed after pressing one of the two battery
release buttons.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED blinks, the power tool is ready for use.
1 LED blinks, the power tool is not ready for use.
4 LEDs blink, the power tool is not ready for use.
Note
Battery charge state cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch. If the battery display LEDs blink, please observe the instructions
given in the Troubleshooting section.
4 Technical data

4.1 Cordless metal screwdriver

Rated voltage
Weight
Rated speed under no load
Torque
Socket/bit drive
4
Printed: 27.07.2016 | Doc-Nr: PUB / 5293039 / 000 / 00
Release button with additional function
/
(charge status display activation)
Depth gauge
:
Depth gauge adjustment
∙
Meaning
• Charge status: 75 % to 100 %
• Charge status: 50 % to 75 %
• Charge status: 25 % to 50 %
• Charge status: 10 % to 25 %
• Charge status: < 10 %
• The battery has overheated.
• The power tool is overloaded or has overheated.
21.6 V
DC
5.5 lb
(2.5 kg)
33.3 Hz
(2,000 /min)
9 ftlb
f
(12 Nm)
/ " hex. socket with locking ring
1
4