Thrustmaster Enzo Ferrari Force GT Manual Del Usuario página 3

SELECTING A SWITCH POSITION
Switch in "USB" position
This position should be selected for games which do not require you to connect a gamepad in addition
to the USB wheel.
GAMEPORT connector, we recommend that you simply connect it to your console as well as your
wheel's USB connector. Most recent games will use this position.
Switch in "USB + GAMEPORT" position
This position should be selected for games which require you to connect a gamepad in addition to the
USB wheel (the gamepad allows you to access the setup options and have the game recognize your
Force Feedback wheel). With the Enzo wheel, simply connect both the USB and GAMEPORT
connectors simultaneously to replace the gamepad.
4. Switch on your console. Your wheel will auto-calibrate (the wheel will move during this procedure) and
the Mode LED (8) will turn red to indicate that Force Feedback mode is enabled.
5. In your game's controller setup options, identify the Enzo as a Force Feedback wheel.
You are now ready to play!
B - To play a motorbike, quad or other type of racing game with your Enzo wheel emulating a
gamepad:
1. Switch off your console before connecting the wheel.
2. Connect the GAMEPORT console connector (15) to port 1 of your console and connect the USB
connector (16) to the upper USB port. The position of the USB / USB + GAMEPORT switch (9) is not
important.
3. Switch on your console. While the game is loading up, disconnect the USB connector (16) once the
Playstation 2 logo is displayed, and then reconnect it immediately. (USB RESET)
4. Your wheel will auto-calibrate (the wheel will move during this procedure) and the Mode LED (8) will turn
red to indicate that Force Feedback mode is enabled.
5. In this type of game, your wheel will be recognized as a gamepad. If necessary, verify and modify its
configuration in the controller setup options (the left analog stick for steering, the right analog stick for
the pedal set).
Note: in this type of game, it will not be possible to disable Force Feedback mode, or use "Precision Drive"
mode.
You are now ready to play!
However, in order to avoid having to repeatedly connect/disconnect the
3/4