Call-Waiting; Resetting The Headset; Tips For Nokia Bluetooth Phones; Enhanced Features (For Bluetooth Phones With Hands-Free Profiles) - Jabra BT 205 Manual De Instrucciones

10

Call-waiting*

•
(Recommended) Use standard method from your phone's keypad which typically
involves pressing the "send" button.
OR
•
Press and release once to answer the incoming call and toggle between calls
(some phones do not support this headset feature).
IMPORTANT: Do not hold the
answering a call. This should only be a quick tap, so you don't put the headset into
pairing mode by accident.
* See Enhanced features section for alternative call-waiting instructions for
phones that support the hands-free profile.
TIPS AND SOLUTIONS
11

Resetting the headset

If the headset is not responding or the blue light will not turn on or off after
pairing, you may need to RESET your headset.
1. Fully insert the headset into the charging cradle.
2. Plug the Jabra BT205 AC adaptor into the headset's charging cradle.
3. Plug the AC adaptor into the electrical outlet.
4. Leave the headset in the charging cradle for about 3 seconds, then remove the
headset (see Fig. 1).
5. Unplug the AC adaptor from the charging cradle.
12

Tips for Nokia Bluetooth phones

Please ensure that the headset is allowed by the phone to connect without
authorization. To do this, you must adjust your phone's settings.
Set the following menu options:
•
Menu > Bluetooth > View Paired Devices > select your headset, press "Options"
> Request conn. authorization? — No
6
button down too long when making, ending, or
Enhanced features (for Bluetooth phones
13
with hands-free profiles)
Enhanced features are available for phones that support the hands-free Bluetooth
profile such as Nokia 3600, 3650, 6310, 6310i, 8910, 8910i, Siemens S55 and
S56. Check your phone's instruction guide or contact the phone manufacturer if
you are not sure if your phone supports the hands-free Bluetooth profile.
You can enable these enhanced features by using the following alternative
pairing sequence.
"Pairing" to a Bluetooth phone with hands-free profile:
1. Ensure headset is off (see Turning headset on/off section).
2. Press and hold plus the volume up button until you see a solid blue light
(approximately 8 seconds), then release (see Fig. 2).
3. Set your Bluetooth phone to "discover" the headset by following your phone's
instruction guide. Typically, the steps involve going to a "setup", "connect", or
"Bluetooth" menu on your phone and then selecting the option to "discover"
a Bluetooth device*.
4. Your phone will find the "Jabra BT205" headset and ask if you want to pair with it.
Confirm this by pressing "yes" or "ok"
5. Enter passkey or PIN = 0000 (4 zeros), then press "yes" or "ok".
* Phone-specific pairing instructions and the most current list of phones with
hands-free profile can be found online at www.Jabra.com
IMPORTANT: If pairing was successful, the blue indicator light will briefly flash rapidly
before going back to flashing every 3 seconds. If unsuccessful, the light remains solid,
and you'll need to reattempt pairing (see steps 3–5 above).
Once you're done pairing, the following new headset features will be available:
•
Last number redial (when not on a call)
While the headset is on, press and hold
release immediately.
•
Rejecting an incoming call (when not on a call)
When your phone rings, press and hold
release immediately.
until you hear 2 short beeps,
until you hear 2 short beeps,
7