Routine Inspections; Operation; After Finishing Work; Maintenance - Skymsen PA-14-N Manual De Instrucciones

4.3 Routine Inspections

4.3.1 Advice
When checking the tension of belts and chains, DO NOT insert your fingers between the
belts and the pulleys and nor between the chain and the gears.
4.3.2 Precautions
Check the motor and sliding or turning parts of the machine in case of abnormal noise.
Check the tension of belts and chains and replace the set when belts or chains show signs
of wearing.
When checking the tension of belts or chains DO NOT insert your fingers between belts
and pulleys, nor between the chains and gears.

4.4 Operation

4.4.1 Advices
Do not work with long hair that may touch any part of the appliance, because they may
cause serious accidents. Tie them up and to the back, cover it with a scarf.
Only trained and qualified users can operate the appliance.
NEVER operate the appliance without any safety equipment.

4.5 After finishing work

4.5.1 Precautions
Always clean the appliance after its usage. You should do that by disconnecting it from the
power grid. Only start washing after the appliance is completely turned off.
Put the components back to the appliance before you turn in on again.
Check the fluids levels.
When checking the tension of the belts and chains. Do NOT put your fingers between the
chains and also between the belts and chains.

4.6 Maintenance

4.6.1 Danger
15