Scanning The Channel Banks For Free Channels - Sennheiser EM 550 G2 Manual De Usuario

Scanning the channel banks for free channels

Scan
Before putting one or several transmission links into operation, you should
scan the channel banks for free channels.
Displaying a list of all free channels
Via the
Scan
all channel banks.
Channel list
Scan new
Scan reset
1 2 3 4
Bank
Free 20 20 17 11
5 6 7 8 U
Bank
12 20 02 03 20
Free
Channel
1.01
786.300 MHz
B.CH
Starting the scan
Scan
Channel list
Scan new
Scan reset
Bank 1 2 3 4
20 20 17 11
Free
5 6 7 8 U
Bank
12 20 02 03 20
Free
Releasing locked channels
Scan
Channel list
Scan new
Scan reset
Bank 1 2 3 4
20
Free 20 18 12
5 6 7 8 U
Bank
16 20 15 11 20
Free
"Channel list" menu, you can display the number of free channels for
Select the "Scan" menu.
Select "Channel list" to display the last scan result. The illustrated list is an
example list and may look different in other frequency ranges. The
number of free channels is displayed for all channel banks.
For further details, select a channel bank by using the
and then press the SET button. This gets you into the "Channel" menu
where you can select a channel of this channel bank or display the
frequency of a channel.
Before starting the scan, switch all transmitters of your system off, since
channels used by switched-on transmitters will not be displayed as "free
channels".
Select the "Scan" menu.
Select "Scan new" and confirm your selection by pressing the
Note:
The scanning process takes approx. 1 minute.
After the scan is completed, the number of free channels is displayed for
all channel banks. Channels that are used or subject to interference are
locked and cannot be selected. The same result is displayed when
selecting the "Channel list" menu.
For further details, select a channel bank by using the
and then press the SET button. This gets you into the "Channel" menu
where you can select a channel of this channel bank or display the
frequency of a channel.
Select the "Scan" menu.
Select "Scan reset" and confirm your selection by pressing the
The last scan result is deleted and all channels can now be selected again.
/ rocker button
SET button.
/ rocker button
SET button.
21