Studio Settings - Blackmagic Studio Camera Manual De Instalación Y Funcionamiento

Rear Tally Brightness
Changes the brightness of the rear tally light. Settings include: low, medium and high.
The default setting is medium.
Tally Light Brightness
Changes the brightness of the tally light on Micro Studio Camera 4K. The default setting is
medium but you can also set it to high, low or off.
If you have set the tally brightness to 'off', the tally light will illuminate when your camera is
powered on, and then will turn off shortly afterwards.
Display Battery Percentage
Some LP-E6 batteries can tell the camera their charge levels directly via digital serial
communication. If this option is enabled, you can display the battery levels for Micro Studio
Camera 4K using a percentage value instead of graphical bars. However, if you find the
percentage display inaccurate, you can switch back to using graphical bars which measures
of the state of charge directly off the battery.

Studio Settings

To adjust the display settings for the LCD, press the 'menu' button and select the headphones
icon. Use the menu navigation buttons to highlight menus and use the 'set' button to confirm
your selection.
Studio settings – Blackmagic Studio Camera.
NOTE Blackmagic Micro Studio Camera 4K provides these settings in the menu titled
'Setup'.
Camera Number
If you want your Studio Camera to receive tally signals from an ATEM switcher, you'll need to set
the camera number on your camera. This ensures the switcher sends the tally signal to the
correct camera. The camera number can be set to a value of 1-99. The default setting is 1.
Settings 24