Installation - Klarstein 10032053 Manual De Instrucciones

EN
26

INSTALLATION

Transport
• Do not carry the refrigerator horizontally or reversely.
• Do not carry the refrigerator by holding the door or handle; the refrigerator shall be
carried by lifting the bottom.
Place environment
• The refrigerator must be placed on a hard, flat ground; if cushioning is needed,
stable, hard, nonflammable cushion blocks shall be used, rather than the foam
backing of refrigerator.
• The refrigerator shall be kept away from damp locations where water is easy to
splash; water or dirt shall be removed with soft cloth timely to prevent rusting which
may have an effect on the electrical characteristics.
• Place the refrigerator in a well-ventilated place, reserve a certain space around
and behind the refrigerator, and do not cover or block the air grille on the rear
cover plate of compressor at the back of refrigerator; Keep the refrigerator away
from heat source or direct sunlight.
Adjust plastic feet
• When the refrigerator stays in the packing box, plastic feet are in tightened state.
After carrying it out from the packing box for placement, please make sure to adjust
two front plastic feet until the height is suitable; just adjust two plastic feet with a
wrench or directly by hand.
• Plastic feet and rear rollers must touch the ground to prevent the refrigerator from
movement, vibration or noise. When moving the refrigerator, adjust plastic feet
counterclockwise to keep them off the ground, and then push the refrigerator gently
to move it.