Technical Service; Regulatory Information - Heath Zenith SL-6168 Manual De Instalación

Chime does not sound:
• Red light on the transmitter does not light. Check battery polarity. Replace
the transmitter battery.
• Red light on the transmitter does light. Make sure the transmitter and the
chime channels are the same (See page 4). Make sure the plug-in chime
has power going to it.
Battery seems OK, but the chime does not work when installed:
• Do not mount the transmitter on metal or near metal studs. This reduces
the transmitter range. Use 1/4" to 1/2" (6 to 13 mm) wood shims to move
the transmitter off the metal surface.
• Try different locations for the chime closer to the transmitter.
The range of the door sensor system depends on location, temperature, and
battery condition.
If you experience a problem, follow this guide. You may also want to visit our Web
site at: www.desatech.com. If the problem persists, call* for assistance at 1-
800-858-8501, 7:30 AM to 4:30 PM CST (M-F). You may also write* to:
DESA Specialty Products™
P.O. Box 90004, Bowling Green, KY 42102-9004
ATTN: Technical Service Specialty Products
* If contacting Technical Service, please have the following information avail-
able: Model Number, Date of Purchase, and Place of Purchase.
No Service Parts Available for this Product
This device (Models SL-6166-RX-A and SL-6168-TX) complies with Part 15
of the FCC Rules and RSS-210 of Industry Canada. Operation is subject to
the following two conditions: (1) this device may not cause harmful interfer-
ence, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
The user is cautioned that changes or modifications not expressly approved
by the party responsible for regulatory compliance could void the user's au-
thority to operate the equipment.
595-5724-03
Troubleshooting

Technical Service

(Do Not Send Products)

Regulatory Information

-5-