Celestron 44120 Manual Del Usuario página 7

4. Seeing Crystals: One of the easiest slides to make is a Crystal slide. Here's how it's done:
a. Use your measuring cup to measure one or two ounces of hot (not boiling) water and pour it into
a clean cup.
b. Slowly add as much table salt to the water as will dissolve. Stir continuously while pouring.
c. Use the plastic Dropper to place one or two drops of the salt solution onto a clean slide as
shown in Figure 4.
d. Set the slide aside and allow it to dry completely.
Figure 4
i. If you wish to save the crystal slides, use a toothpick to put one or two small drops of Gum Media
on the slide and gently place a Side Cover (M) and press down flat to spread the media evenly
under the slip.
j. Attach a label (M) and set aside the slide to let the Gum Media dry (2 days).
k. If you do not wish to save the slides, simply wash the slides clean with clean water and soap.
l. Try other salts and sugars in the same manner to create other Crystal Slides!
5. Creating Smears:
a. Using your Scalpel (B) gently scrape off small shavings from the surface of a freshly cut potato.
b. Smear the shavings onto a clean slide as shown in Figure 5.
c. This creates a very thin specimen that is ready to view under the microscope.
Figure 5
e. Clean your tools, using the "Flush" cup.
f. When the slide is completely dried, it
should be covered in a white substance.
Now place the slide on the Microscope
Stage and center it over the hole in
the Stage.
g. Flip the Illuminator over to turn on
the light bulb. Set the objective to the
shortest. Look through the microscope
eyepiece and focus in on the
specimen. You should see crystals!
h. Experiment with different objectives
and note the changes.
6. Preparing a Mount: Preparing a
mount refers to larger objects like
the petal of a plant or an ant leg.
a. Dip your Scalpel in some clean water
and make a smear across a clean slide.
b. Use your Tweezers (A) to place a
portion of an insect wing, or other
part, on the slide.
6