"Pause" Function - Nice WMS01S Instrucciones Y Advertencias Para La Instalación Y El Uso

The user can take the sun screen to a desired position
at any time, using the p, ■, q keys and can pause the
system (paragraph 8.1).
8 - Controls and settings that can be
modified by the user

8.1 - "Pause" Function

This function allows to temporarily suspend the automatic
functioning of the system. It is useful to prevent the shutter
from moving autonomously during maintenance of the
automation, when cleaning the glass, watering plants on
the window ledge etc.
The function can be customised within the programming
environment by setting the "Manual pause" or "Timed pause"
option. For the latter it is also possible to set a desired pause
value (minimum 10 minutes). To activate or deactivate the
pause in the user screen, proceed as follows:
7
4 – English
- Activate Pause:
(with display on) Hold the t key down until the
(manual pause) or (timed pause) symbol appears
on the display.
- Deactivate Pause:
• (with display on) If the display shows the
hold the t key down until the
symbol disappears.
• (with display on) If the display shows the
deactivation takes place automatically when the time
programmed by the installer expires. If the pause is to be
activated in advance, hold the t key down until the
symbol disappears from the display.
8.2 - Regulation of the position of the cursor-
thresholds (fig. 8)
The user can shift the cursor-threshold along the "Light
set" bar, within the limits pre-set by the installer, positioning
it in correspondence of desired light values. Proceed as fol-
lows to move the cursor:
01. With the display on, briefly press the t key: the cur-
sor-thresholds starts to flash.
02. If the level is to be increased, hold the p key down or
if the level is to be decreases, hold the q key down.
03. Finally, press the ° key to memorise the new position
and go back to the user screen.
If the regulation made does not have to be memorised,
wait for the display to switch off or press the ■ key.
symbol,
symbol,
8