Nice WMS01S Instrucciones Y Advertencias Para La Instalación Y El Uso página 12

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 31
• "Language"
This function allows to select the language of the
display texts.
To set a language, select the "Settings" menu and confirm
with the ° key. From the sub-menu, select the "Language"
function and confirm using the ° key. In the screen that
appears, use the p and q keys to select the desired lan-
guage and confirm using the ° key.
• "Test"
Se the "What to do if..." chapter.
6 – English
What to do if...
(troubleshooting)
• If the shutter does not move during the day and the
symbol is present on the display.
Replace the battery.
• If the display does not switch-on when any key is
pressed.
Try and replace the battery (fig. 9).
• If the shutter does not move during the day.
Check with different light conditions (from dawn to dusk)
whether the light value given in the "Intensity" bar exceeds
the intervention thresholds in the "Light set" bar and, as a
consequence, whether the system moves the shutter. If
this does not take place, try and move the cursor-thre-
sholds into a new position (paragraph 8.2).
• If the shutter moves too often during the day.
Try and modify the hysteresis space by referring to the
description given in chapter 10 ("Hysteresis" function).
• If a test is to be performed on parts of the product, to
check their regular functioning.
Enter the "Settings" menu, select the "Test" function and
confirm with the ° key.
At this point it is possible to perform the following tests:
a) identification of the keys: by pressing each individual
key, the code appears that identifies the key pressed
(example: t = key = code "P1"; p = key code "P2";
etc.).
b) check the display: hold the t key down until the
display is all black (this is used to check the state of the
pixel matrix). Then, pressing the key again, "1 2 3" will
appear. Pressing a third time all of the characters used on
the display appear and a fourth press makes the display
appear all black again.
Press the ° key to exit this test.
c) check the light sensors: hold the ■ key down until the
"Intensity Rear" bar appears on the display. By pressing
the key a second time the "Intensity Front" bar appears
(used to check correct functioning of the light sensors).
Press the ° key to exit this test.
d) prolonged transmission of the "STOP" control:
hold the q key down until "STOP" appears on the
display and then release the key: the transmitter starts to
transmit the Stop command continuously. To interrupt
transmission, press the same key again (useful function
for carrying out radio transmission tests).
Press the ° key to exit this test.
To exit the "Test" function definitively, hold the ° key down
until the display shows the screen with 3 icons from the
1
st
level.
9

Publicidad

Tabla de contenido
loading

Tabla de contenido