Modes Of Operation - Heathrow Scientific Vortexer Manual De Instrucciones

Your Vortexer is supplied with a pop-on mixing head
attachment and an AC power cord located in the top
corrugated box insert
you fully unpack your Vortexer from the package and
remove the protective plastic bag, install the mixing head
attachment (check that it is right side up).
IMPORTANT:
YOU MUST PULL OUT INNER FRONT
SUPPORT CARD
HEATHROW SCIENTIFIC
HANDS TO GRASP THE UNIT WHEN LIFTING
OUT OF THE BOX.
TO INSTALL THE MIXING HEAD ATTACHMENT YOU
MUST PRESS DOWN FIRMLY WITH BOTH HANDS
UNTIL YOU FEEL THE MIXING HEAD ATTACHMENT
SNAP FULLY INTO PLACE.
This will ensure that the mixing head attachment will not
come off the Vortexer during operation.
Place the Vortex Mixer on a level, stable surface near the
grounded electrical outlet. The surface should be clean and
free of dust to ensure that the feet grip the surface firmly.
Allow sufficient clearance on all sides of the unit for proper
ventilation and usage. With the power switch in the OFF
position (central on the vertical 3-position), plug the power
cord into the back of the Vortex Mixer.
Note: On units equipped with a frequency switch (located above the power cord connection
on rear) set switch to either 50Hz or 60Hz to match the local power company supply.
Turn the speed rotary dial turned all the way to the left- (in the OFF position). Plug the device
into a properly grounded outlet.
Power
switch in
the OFF
position
- center

Modes of Operation:

WARNING:
Heathrow Scientific, the protection provided by the equipment may be
impaired.
Duty Cycle for ALL VERSIONS: Maximum run time of 20 minutes
followed by 60 minute OFF time when in Continuous Operation mode.
100V-110V Vortexer: Set power input frequency switch on rear of unit to
either 50Hz or 60Hz to match local power company supply.
220V-240V Vortexer: Set power input frequency switch on rear of unit to
either 50Hz or 60Hz to match local power company supply.
6
of the product packaging. After
1
BEFORE REMOVING YOUR
3
VORTEXER. USE TWO
®
4
20 MIN. MAX RUN TIME
FOLLOWED BY 60 MIN. OFF TIME
20 MIN. de FONCTIONNEMENT MAX
SUIVE PAR 60 MIN. HORS du TEMPS
20 MIN. MAX LAUFZEIT
VON 60 MIN. AUS ZEIT GEFOLGT
20 MIN. de TIEMPO de EJECTCIÓN MAX
SEGUIDO POR el60 MIN. de PARO
220V - 240V / 50W/0.21A
60 Hz 50 Hz
Back view of Vortexer
If the Vortexer is used in a manner not specified by
50Hz-60Hz
frequency
switch
location
1
2
3
4
Apply even pressure to ensure
the head is secure
To immediately shut
off power to Vortexer
device, pull out the
AC cord from the
lower central back
area of the device