Sub-Zero ICB700TR Instrucciones De Instalación página 19

INTEGRATED
PANEL
Before attaching the door panel to the door,
place two screws in the center of each
mounting position, just enough that the slotted
holes on the hinge side door panel bracket will
slide under the heads. These positioning
P A N E L
screws will support the door panel during
R E Q U I R E M E N T S
installation and adjustment. Refer to illustra-
tion 14 below.
Door and drawer Install the door panel by engaging the tabbed
panels must be a
bracket to the handle side of the door first and
minimum of 16 mm
then sliding the hinge side mounting bracket
thick.
onto the positioning screws on the hinge side
The door panel
of the door. The panel can be adjusted 6 mm
cannot exceed 18 kg
up and down and side to side.
and each drawer
Once the door panel is in place and adjusted
panel must not
exceed 5 kg for 686 correctly, attach the six remaining #10 x 12,7
mm wide units. For
mm screws to the hinge side mounting bracket
914 mm wide units,
and install the magnetic decorative caps as
the door panel
shown in illustration 14.
weight limit is 24 kg
and 7 kg for each
drawer panel.
20
I N S TA L L AT I O N I N S T R U C T I O N S
I N S TA L L AT I O N
As the reveal between cabinets and the
unit decreases, the potential exists for
severe finger pinching if fingers are placed
in the opening when the door is closing.
Illus. 14
D R A W E R P A N E L I N S TA L L AT I O N
Remove the mounting hardware provided and
set aside. As with the door panel, you should
work on the back side of each drawer panel
and protect the fronts of these panels.
Position the top edge of the template flush
with the top edge of each drawer. For the top
drawer, there is only one location for the lower
mounting bracket to be placed. However, the
bottom drawer allows a second option, invert-
ing the lower mounting bracket, depending on
the height and thickness or detail of the panel.
Refer to illustration 15 below.
Secure the template in place with tape or a
small clamp and mark positions for the pilot
holes. Remove the template and drill the pilot
holes. Place the mounting brackets in the
proper location with the tabbed bracket on top
and 'L' bracket on the bottom of the panel.
Fasten brackets securely with the #8 x 12,7 mm
screws provided. Refer to illustration 16 below.
Illustration 13 on page 17 also shows the
mounting hardware location for drawer panels.
Top Of Template
Flush With Top Of
Drawer Panel
Gap On Side
Edges Will Vary
According To
Design
Back Of
Drawer Panel
Illus. 15 Illus. 16