General Operation; Mode Selector Dial - Hoover FloorMate SpinScrub Manual De Instrucciones

General operation

Your HOOVER FloorMate™ SpinScrub™ Cleaner can be used to both vacuum dry debris and wet
clean non-carpeted floor surfaces such as vinyl, tile and sealed wood. It is not intended for use on
carpet or rugs.
CAUTION: To prevent damage to wood floors, follow the flooring manufacturer's cleaning
recommendations.
If using cleaner on sealed wood floors, inspect floor surface for worn finish, bare wood or sepa-
rated joints. Do not use FloorMate™ SpinScrub™ Cleaner to wet clean sealed wood floors if any
of these conditions exist.

Mode selector dial

15
16
8
A
The Mode selector dial (A) turns
15
the brushes on and off.
For dry debris pickup, turn the dial to the
16
DRY VAC position. In this position, the
brushes will not rotate and are raised off the
floor surface.
To wet clean with brushes turned ON, turn the
dial to the WASH position.
For wet pickup, turn the dial to the WET PICK-
UP position.
Refer to "How to clean" section for complete
cleaning instructions.