Flush Installation Of Hob; Installation Of The Hob In The Worktop Cut-Out - bora PG 11-000 Instrucciones De Instalación, Operación Y Mantenimiento

... Installation
Installation
■ The use of solid timber wall strips behind the built-in cooktop on the worktop is
permissible, provided the required minimum distances are maintained.
■ The use of plastic wall strips is not permissible.
■ Changes in the surface colour normally result from the effect of light.

Flush installation of hob

► Place the cooktop in the cut-out. Seal
the gap between the cooktop and the
hob with
silicone adhesive. Remove excess
silicone adhesive with a putty knife.

Installation of the hob in the worktop cut-out

► Place the cooktop in the cut-out and secure it with the clamps.
The BORA logo must be positioned in the rear right corner of the built-in hob.
a temperature-resistant
temperature-resistant
silicone adhesive
11