ION Complete LP Guia De Inicio Rapido página 5

Playback
Bluetooth Mode
1. Turn on your Bluetooth device.
2. Press the Mode button until BT AUX is seen on the display. It will automatically go into
pairing mode to search for Bluetooth devices.
3. Navigate to your Bluetooth device's setup screen, find "Complete LP", and connect.
Note: If your Bluetooth device prompts for a pairing code, enter "0000".
Tape Player Mode
1. Press the Mode button until TAPE is seen on the display.
2. Insert the tape with the thicker side of the tape facing to the right of tape tray.
3. Push the Eject/Fast Forward button 1/2 way down to toggle between fast forward and
play mode.
4. Push the Eject/Fast Forward button completely down to eject the tape.
Note: Remove your 1/8" (3.5 mm) cable from the Line In before going to Tuner mode in order
to hear the station.
Vinyl Mode
1. Platter – Place your record here.
2. 45 RPM Adapter Holder – Holds the included
45 RPM adapter. When not using the adapter,
please place it in this holder.
3. Tonearm – The fixed tonearm can be raised
and lowered by hand, or by pressing the raise
/ lower lever.
4. Arm Clip – This specially designed arm clip
secures the tonearm while at rest or when not
in use. The arm clip has been designed to
remain in the up position while unlocked.
5. Raise / Lower Lever – Raises and lowers the
tonearm.
6. 33 / 45 / 78 Switch – This switch controls the
speed of the turntable platter.
Note: For best results when playing 78 RPM
vinyl records, use a 78 stylus (sold separately).
Only use a 78 stylus with 78 RPM vinyl records.
7. Autostop switch – This switch turns autostop
on or off. When autostop is on, the platter will
start spinning when the tonearm is placed over
the record and stop spinning when the record
has reached the end. (When Autostop is off, the
platter will always spin regardless of the
position of the tonearm.)
Note: If your vinyl record stops before it
reaches the end of the music, turn Autostop to
the off position for this particular record. This is
generally recommended for 45 RPM records.
1
IMPORTANT: Place the included felt
slipmat on the platter; then place your
record on the felt slipmat to carefully hold
your records.
IMPORTANT: Remove
cartridge cover (needle cover) before
operating the turntable.
*WARNING: The RCA outputs are LINE
level. Please only connect these to LINE
level inputs. You may damage your
receiver if you plug in a LINE level device
into a PHONO level input.
2
3
5
6
7
4
the plastic
5