General Information - Anthron Lory SAFE Manual De Usuario

connectors (e.g. use a rigging plate, or connectors made for tri-
axial loading) (fig. 10C). Always secure the device, do not girth
hitch, and protect sharp edges (fig. 10D)! If the anchor is part of a
fall-arrest system, use measures to absorb shock loads.

GENERAL INFORMATION

Regular examination:
• Do not hesitate to retire the device if it shows signs of wear or
after an overload or a major impact. They could cause
internal or invisible damage that may significantly weaken its
strength. In case of uncertainty treat the device as damaged
or consult ANTHRON.
• Regular periodical inspections must be carried out by a
competent person at least once a year according to
manufacturer's recommendations. For this purpose an
inspection record should be established (see the backside of
these instructions). Furthermore, we would sincerely
recommend one set of equipment is used by one person only
as its history of use is best traced and understood in this way.
• Before each use, it is obligatory to check the device and
verify that all its components (handle, jamming cleat,
flanges) are faultless and in good working condition.
Packing, storage, maintenance and cleaning
Each product is packed with its INSTRUCTIONS FOR USE.
Proper maintenance and storage are imperative to ensure
correct functioning of the product (as well as all your
equipment) and thus your safety.
Clean the product with a brush under running cold water of
domestic supply. If the stains persist, clean it in warm water
(maximum 30 °C) with ordinary soap. Then rinse thoroughly,
wipe it with a towel and dry naturally in a shaded ventilated
place away from sources of heat.
If needed, lube sparingly the moving joints of the cam and
handle with silicon based oil.
Temperatures
While it is permissible to use this product within the
temperature range from -20 °C (140°F) to +60 °C (4°F), it is