PLYMOVENT MINIMAN-75 Instrucciones Para El Uso página 10

3. if you have purchased a damper kit d-75 and wish to install it, please continue to follow the steps below. if you have purchased
a halogen lamp hood MM-002 and want to install it you can go to step no.11
4. remove the stickers covering the mounting holes(a) for the damper and the hose between the nozzle/hood and the outer
tube(b) and mount the "ratchet"(c) to the top of the tube using the supplied pop-rivet(d).
5. Place damper blade(a) inside outer tube(b) Put the ball cassette inside the hole in the pointy part of the damper turning knob(d)
and insert the damper shaft(c) from the top side of the tube thru the damper blade, you may have to tapp it in place with a ham-
mer. align the knob with the damper blade in sutch a way that knob is pointing along the tube when the damper is fully open
(e) secure damper blade to the shaft with the supplied "grabber screw". correct position of the turning knob is when there are
approximately 1mm, 0.04" between the damper ratchet and knob. assemble in order the rubber washer, spring washer and star-
lock washer at the damper shaft.
A
C
6. reattach the hose between hood and outer tube. you have now completed the installation of the damper kit.
051113/0 MiniMan-75
A
B
E
B
D
C
D
D
MiniMan/75/usa/can/10/14
EN - 9