Tabla de contenido
Publicidad
SPITBULL 36V
When working with the machine, always hold
it firmly with both hands and provide for a
secure stance. The power tool is guided more
secure with both hands.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
secure than by hand.
Always wait until the machine has come to
a complete stop before placing it down. The
tool insert can jam and lead to loss of control
over the power tool.
Do not open the battery. Danger of short-cir-
cuiting.
Protect the battery against heat,
e. g., against continuous intense
sunlight, fire, water, and moisture.
Danger of explosion.
In case of damage and improper use of the
battery, vapours may be emitted. Ventilate
the area and seek medical help in case of
complaints. The vapours can irritate the respi-
ratory system.
Use the battery only in conjunction with your
SPIT power tool. This measure alone pro-
tects the battery against dangerous overload.
The battery can be damaged by pointed ob-
jects such as nails or screwdrivers or by
force applied externally. An internal short cir-
cuit can occur and the battery can burn, smoke,
explode or overheat.
2. Product Description and Speci-
fications
Read all safety warnings and all
instructions. Failure to follow the
warnings and instructions may result
in electric shock, fire and/or serious
injury.
Intended Use
The machine is intended for hammer drilling in
concrete, brick and stone, as well as for light chi-
selling work. It is also suitable for drilling without
impact in wood, metal, ceramic and plastic. Ma-
chines with electronic control and right/left rota-
tion are also suitable for screwdriving.
Product Features
The numbering of the product features refers to
the illustration of the machine on the graphics
page 2.
1
SDS-plus tool holder.
2
Dust protection cap.
3
Locking sleeve.
4
Handle (insulated gripping surface).
5
Rotational direction switch.
6
On/Off switch.
7
Release button for mode selector switch.
8
Battery unlocking button.
9
Temperature control indicator.
10 Battery charge-control indicator.
11 Button for charge-control indicator.
12 Battery.
13 Button for depth stop adjustment.
14 Auxiliary handle (insulated gripping sur-
face/graduated rule).
15 Screw bit SW13.
16 Maximum screwing speed selection.
17 Worklight.
Noise/Vibration Information
Sound emission values determined according to
EN 60745-2-6.
Typically the A-weighted noise levels of the pro-
duct are: Sound pressure level 90 dB(A); sound
power level 101 dB(A). Uncertainty K=3 dB.
Wear hearing protection! Vibration total values
ah (triax vector sum) and uncertainty K deter-
mined according to EN 60745.
▪ Hammer drilling into concrete: A
K=1.5 m/s
,
2
▪ Drilling in metal: A
h
▪ Screwdriving without impact: A
K=1.5 m/s
2
The vibration level given in this information
sheet has been measured in accordance with a
standardised test given in EN 60745 and may be
used to compare one tool with another. It may be
used for a preliminary assessment of exposure.
The declared vibration emission level represents
the main applications of the tool. However if the
English
=20 m/s
h
<2.5 m/s
, K=1.5 m/s
2
<2.5 m/s
h
17
,
2
.
2
,
2
Publicidad
Tabla de contenido
