Tabla de contenido
Publicidad
SPITBULL 36V
● The "screw" position is ideal for
hammer tools, plastic plugs with me-
tal screws or small concrete screws
with a PH, PZ or T head. A depth
gauge is included in the kit to prevent
the screw sinking too deep in the
plastic plug.
● The "nut" position is ideal for plugs
with a hexagon head (concrete screw
type), or a nut (anchor stud type), in
SW13 or SW10 standardized sizes.
The screws used must not exceed
a diameter of 8 mm and/or must
not require a torque load exceeding
15Nm.
Put the plug in the hole and apply the exten-
sion with the bit to the head of the plug, or to the
rotating nut. Start the tool while applying pres-
sure to the plug until it has been inserted to the
desired depth.
Even if the speed is limited, it is advisable
to release the speed variator gradually at the
end of the screw travel to avoid excessive
torque return.
Use only screwdriver bits that match the
screw head.
Regularly clean and grease lightly your ac-
cessory kit.
Recommendations for Optimal Han-
dling of the Battery
Protect the battery against moisture and water.
Store the battery only within a temperature
range between 0 °C and 50 °C. As an example,
do not leave the battery in the car in summer.
Occasionally clean the venting slots of the batte-
ry using a soft, clean and dry brush.
A significantly reduced working period after
charging indicates that the battery is used and
must be replaced.
Observe the notes for disposal.
3. Battery Charger
Read all safety warnings and
all instructions. Failure to follow
the warnings and instructions may
result in electric shock, fire and/or
serious injury.
Save these instructions.
Use the battery charger only when you fully un-
derstand and can perform all functions without
limitation, or have received appropriate instruc-
tions.
Safety Notes
Only charge SPIT lithium-ion batteries with
a capacity over 1.3 Ah (more than 4 batte-
ry cells). The battery voltage must match
the battery charging voltage of the charger.
Otherwise there is danger of fire and explosion.
Keep the battery charger away from rain or
moisture. Penetration of water in the battery
charger increases the risk of an electric shock.
Keep the battery charger clean. Contamina-
tion can lead to danger of an electric shock.
Before each use, check the battery charger,
cable and plug. If damage is detected, do not
use the battery charger. Never open the bat-
tery charger yourself. Have repairs perfor-
med only by a qualified technician and only
using original spare parts. Damaged battery
chargers, cables and plugs increase the risk of
an electric shock.
Do not operate the battery charger on easily
inflammable surfaces (e. g., paper, textiles,
etc.) or surroundings. The heating of the batte-
ry charger during the charging process can pose
a fire hazard.
In case of damage and improper use of the
battery, vapours may be emitted. Ventilate
the area and seek medical help in case of
complaints. The vapours can irritate the respi-
ratory system.
21
English
Publicidad
Tabla de contenido
