Tabla de contenido
Publicidad
22
English
Do not cover the ventilation slots of the bat-
tery charger. Otherwise, the battery charger
can overheat and no longer operate properly.
Technical Data
Battery Charger
Article number
Battery charging voltage (auto-
matic voltage detection)
Charging current
Allowable charging temperature
range
Charging time for battery capacity,
approx.
6,2 Ah
Weight according to EPTAProce-
dure 01:2014
Protection class
Operation
Starting Operation
Observe the mains voltage! The voltage of
the power supply must correspond with the data
given on the nameplate of the battery charger.
Battery chargers marked with 230 V can also be
operated with 220 V.
Meaning of the Indication Elements
Continuous red light
Battery too hot or too cold. The
charging operation begins automati-
cally as soon as the battery returns
to the permitted temperature range.
Red light flashing (quickly)
Short circuit between the charging
contacts.
Put the battery back in place.
Defective battery.
Continuous green light
Charging is fully charged.
054494
V
28–36
A
7,0 max.
°C
0 – 45
(80%) 100%
min.
45
kg
Remove the battery from
the charger.
Disconnect the device!
Check for foreign matter in
the charger housing.
Use a new battery
4. Maintenance and Service
Maintenance and Cleaning
Before any work on the machine itself (e. g.
maintenance, tool change, etc.) as well as
75
during transport and storage, remove the
battery from the power tool. There is danger
0,97
of injury when unintentionally actuating the On/
II
Off switch.
For safe and proper working, always keep
the machine and ventilation slots clean.
A damaged dust protection cap should be
changed immediately. We recommend ha-
ving this carried out by an after-sales ser-
vice. Clean the tool holder 1 each time after
using.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for SPIT power tools.
After-sales Service and Application
Service
Our after-sales service responds to your ques-
tions concerning maintenance and repair of
your product as well as spare parts. Exploded
views and information on spare parts can also
be found under: www.spitpaslode.com
Transport
The contained lithium-ion batteries are subject
to the Dangerous Goods Legislation require-
ments. The user can transport the batteries by
road without further requirements.
When being transported by third parties (e.g.: air
transport or forwarding agency), special require-
SPITBULL 36V
Green light flashing (quickly)
Charging is in progress.
Green light flashing /no battery
(slow)
The device is ready to operate but
the battery compartment is empty.
Publicidad
Tabla de contenido
