Sauder Palladia Serie Manual De Instrucciones página 22

Step 17
Insert both VALANCE CLIPS (FF) into the grooves in the corners of the
å
VALANCES (Q, R, and S). Be sure the hole remains out of the groove as
shown. Follow the enlarged diagrams closely.
Now, adjust the VALANCES to line up the corners and fasten the
å
VALANCE CLIPS (FF) to the VALANCE CONNECTORS (DD).
Use two BLACK 1-5/8" PAN HEAD SCREWS (VV). Tighten the SCREWS
å
until they begin to turn hard. Do not overtighten.
Next, completely tighten the SCREW
å
in each VALANCE BRACKET.
Page 22
FF
DD
VV
BLACK 1-5/8" PAN HEAD SCREW
(2 used in this step)
412308
Use a BLACK 1-5/8" PAN HEAD
SCREW (VV) through the hole
in the CLIP and into the hole in
the VALANCE CONNECTOR.
DD
www.sauder.com/services
FF