WALCOM GENESI CARBON 360 HTE Light BASE Manual De Instrucciones página 15

FAILURES AND REMOVAL OF THEIR CAUSES
FAULT
Intermittent fan spray
Air bubbles
in the cup
Uneven fan spray
Product leaks from
the nozzle during
"1st phase" operations
Air leaks without
pulling back
the lever
Air leaks when
lever is pulled back
NOTES
CAUSE
1 - Nozzle and sealing cone to the body are not clean;
2 - Nozzle has not been tightened enough;
3 - Ring nut and cap not properly tightened to the body;
4 - Worn out or damaged nozzle sealing cone;
5 - Deflector (S.Xlight-S.Kombat models) damaged and/
or missing;
6 - Loose stuffing box needle;
7 - Worn out or damaged stuffing box needle;
8 - Cup or cup coupling not tight enough.
1 - Nozzle and needle are not clean;
2 - Stuffing box has not been properly adjusted/set;
3 - Cap with damaged air holes, damaged nozzle, or a
worn out/damaged needle.
1 - Nozzle and needle are not clean;
2 - Needle pusher spring missing and/or needle-adjusting
handwheel missing;
3 - Rod sliding issues;
4 - Damaged/worn out needle or nozzle;
5 - Needle stuffing box is too tight.
1 - Rod sliding issues;
2 - Needle / stuffing box sliding problems;
3 - Rear air stuffing box is worn out;
4 - Ribbed or scratched valve body;
5 - Worn out valve body O-ring.
1 - Dirty front rod;
2 - Worn stuffing box or front rod.
1 - Thoroughly clean the nozzle and sealing cone to the body;
2 - Tighten the nozzle properly;
3 - Tighten the ring nut and cap properly;
4 - Replace the nozzle;
5 - Replace the deflector;
6 - Adjust the stuffing box properly (minimum needle
sliding friction);
7 - Replace the stuffing box needle;
8 - Properly tighten the cup or cup coupling.
1 - Carefully clean the cap/nozzle/needle paying
attention to clean nozzle holes completely
(use cleaning kit 90109/W);
2 - Adjust the stuffing box properly (minimum needle
sliding friction);
3 - Replace needle/nozzle/cap set.
1 - Clean needle and nozzle properly;
2 - Insert the spring and/or screw the needle-adjusting
handwheel back on;
3 - Properly lubricate the rear and front rods with mineral oil;
4 - Replace needle and nozzle;
5 - Adjust the stuffing box properly (minimum needle
sliding friction).
1 - Properly lubricate the rear rod with mineral oil;
2 - Adjust the stuffing box properly (minimum needle
sliding friction);
3 - Replace rear set screw;
4 - Replace valve body;
5 - Replace valve body O-ring.
1 - Clean and lubricate front rod;
2 - Replace valve body including the rod.
15
SOLUTION
EN