Setting The Clock; To Set The Minute Timer - Kenmore 790.4061 Serie Manual De Uso

Setting the Clock

Note: The time of day must first be set in order to operate the oven.
To Set the Clock
When the range is first plugged in, or when the power supply to the appliance has been interrupted, the display
will show "12:00" and flash PF (power failure).
1. Press once (do not hold pad down).
2. Within 5 seconds, press and hold the
3. To reject the change, press
Note: The clock cannot be changed during any bake or self-clean cycle.
Changing Between 12 or 24 Hour Time of Day Display:
1. Press and hold
will beep once.
2. Press either or
3. Wait 5 seconds to accept the changes or press
4. Reset the correct time as described in To set the Clock above. Please note that if the 24 hour time of day mode
was chosen, the clock will now display time from 0:00 through 23:59 hours.

To Set the Minute Timer

Timer
Set/Off
1. Press .
2. Press the to increase the time in 1 minute increments. Press and hold
timer can be set for any amount of time from 1 minute to 11 hours and 59 minutes.
3. The display shows the timer countdown in seconds when you set the minute timer for less than 59 minutes.
When the minute timer is set for more than 1 hour the display shows the timer countdown in minutes.
4. When the set time has run out, the timer will beep until
Note: The minute timer does not start or stop cooking. It serves as an extra timer in the kitchen that will beep
when the set time has run out. The minute timer can be used alone or during any of the other oven functions.
When the minute timer is in use with any other function, the function countdown will be shown in the display.
To Cancel the Minute Timer before the set time has run out: Press
To Set Add 1 Minute Feature
Add 1
Minute
When the pad is pressed, 1 minute is added to the minute Timer feature if it is already active. If the minute
Timer feature is not active and the
begin counting down from 1 minute.
or
STOP
Clear . If the pad is not touched the change will be accepted after 5 seconds.
for 7 seconds. After 7 seconds, "12h" or "24h" will appear in the display and the control
to switch between the 12 and 24 hour time of day display.
Add 1
Minute
pad is pressed, the Minute Timer feature will become active and will
until the correct time of day appears in the display.
STOP
Clear to cancel and return to the time of day display.
Timer
Set/Off
is pressed.
Timer
Set/Off
.
8
pad to increase the time faster. The