Troubleshooting
PROBLEM
Top lock does not get
locked
Vibration of the grinder
when in use
Grinder stops during
grinding
Cocina Sin Límites, S.L.
CAUSE
a. Stone assembly and lock
are not in proper position.
a. Grinder is not placed on
a levelled surface.
b. Rubber legs not in
position
a. Power supply failure
b. Low voltage in power
supply
c. Insufficient water in the
drum
REMEDY
a. Check the main supply
b. Connect wires properly
c. Insert correctly into the socket
d. Re-set using blunt edge pin
a. Place on a levelled surface
b. Check and correct the legs
position
a. Check the main supply.
b. Switch off grinder and wait until
the voltage stabilizes.
c. Add the required quantity of
water.
www.100x100chef.com
25