Reversing The Door - JENN-AIR JUC2450ARW Guia Del Propietario

Installation

Reversing the Door

• To avoid electrical shock which can cause severe
personal injury or death, disconnect power to the
refrigerator before reversing the door.
1. Turn OFF the refrigerator
and disconnect the
power. Remove top
hinge pin with a
1 " Allen wrench.
⁄
8
Remove door by pulling
it out and upward off
bottom hinge pin. Set
aside, face down on
surface that will not
scratch the finish.
Remove the small plastic washer from bottom
hinge pin.
2. Remove the six small
plastic hole plugs from the
left hand hinge holes
using the putty knife.
Using a 5 " socket,
⁄
16
wrench or nut-driver,
remove bottom hinge.
Reinstall hinge, moving it
to the top left hand side.
Using a 1 " Allen wrench, remove the hinge pin
⁄
8
from the top left hinge, and install in top right
hinge. Now move top right hinge to left bottom.
Reinstall the small plastic washer on the bottom
hinge pin. Install hole plugs in right side.
3. Reverse the door interior liner.
• Remove the door seal.
• Open the 6 hinged screw covers
found on the door liner by
sliding the blade of thin putty
knife into the seam on each
cover (be careful not to run the
knife through the hinge found
on each screw cover).
5
, cont.
WARNING
Top of
Refrigerator Hinge
Out
Hinge
Bracket
Up
Hole Plugs
Move
Hinge
• Using a Phillips screwdriver, remove the 6 screws
that are attaching the liner to the door. The
screw covers will rotate with the screws.
• Rotate the door liner 180º and align the screw
holes in the door liner with the well nuts in the
door.
• Reinstall the screws into the well nuts by first
starting all 6 screws and then tightening all 6
screws. This will reattach the door liner to the
Pin
door. Close the screw covers.
• Move the striker plate to the opposite end of the
door.
NOTE: Be sure to install the spacer behind the
striker plate in its correct orientation. Failure to
do this can interfere with the ability to reinstall
the striker plate correctly.
• Reinstall the door seal by pressing it into the
door channel, making certain the corners are
fully inserted.
Rotate
180°
Seam
Door liner
Well nuts
Striker plate
Door
Spacer