How To Reverse Refrigerator Door; How To Install And Remove Handles - JENN-AIR JCB2058GEB Guia Del Usuario

H R
OW TO EVERSE
R D
EFRIGERATOR
Note:
When working directly on door, lay
the interior side of the door down
flat, nonabrasive surface. If using a
floor or table, prepare working
surface with rugs or towels to avoid
damage to door finish.
DOORS WITH TRIM AND
PANELS
1. Perform all steps listed in How to
Remove the Door and Hinges.
2. Perform removal steps listed in How
to Remove and Install Handles.
3. Transfer cabinet
plugs and screws to
opposite side of
cabinet.
4. Remove plugs with
flat blade of
s c r e w d r i v e r
wrapped in masking
tape.
5. Remove center mullion screws with
5 " hex head driver.
⁄
16
6. Locate door stop (B) and door cap (A)
on bottom edge of fresh food door.
Remove with a Phillips screwdriver.
$
• Retain all items for later replacement.
WARNING:
To avoid possible injury and damage to
property, tape decorative panels (some
models) securely into place before
removing side door trim and handles.
7. Remove side door trim (A) and
handle side trim (B) from door by
tapping bottom edges upward with a
soft rubber mallet.
%
• Trim will slide up approximately
and release from
OOR
door.
8. Rotate door panel
180° and tape in place.
9. Remove
extension with
head driver. Flip door
extension (A) so notched corner
turns in toward interior of door (B).
10. Retrieve alternate side door trim
shipped with refrigerator. Install trim
by aligning notches of trim with
metal mounting tabs on side of door.
• Slide trim down until piece locks
into place.
• Tap top of trim with rubber mallet
to insure snug fit.
• Repeat same procedure to install
handle side trim removed in step 7.
11. Replace bottom door cap (A)
removed in step 6. Install door stop
%
(B) on opposite side of door.
$
12. Remove tape from panels.
13. Proceed to next column to reinstall
handle.
$
3
⁄
4
top door
1 " hex
⁄
4
%
$
%
5
" H I
OW TO NSTALL AND
R H
EMOVE ANDLES
In some cases, handles may need to be
removed to transport unit through tight
spaces, reverse doors, or install panels.
Some models may come with handles
shipped separate from the refrigerator
door.
INSTALLING HANDLES
1. Retrieve handle
material (some models).
2. Locate handle
mounting posts on
face of door.
3. Position handle over mounting
posts.
4. Tighten set screws (A)
with a 3 " Allen
⁄
32
wrench
REMOVING HANDLES
1. Locate set screws in handle and
loosen set screws with a
wrench.
2. Lift handle from handle mounting
posts to remove.
Note:
In cases of door
reversal, panel installation, or panel
removal, the mounting posts must be
1
removed. Use a " hex head driver
⁄
4
to remove the post from the door.
from shipping
$
3 " Allen
⁄
32