Tabla de contenido
Publicidad
EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
CHECKING THE CHARGER
If the battery pack does not charge properly:
Check the current at the power outlet with
another tool. Make sure that the outlet is
not turned off.
Check that the charger contacts have not
been shorted by debris or foreign material.
If the surrounding air temperature is not
normal room temperature, move the
charger and battery pack to a location
ZKHUH WKH WHPSHUDWXUH LV EHWZHHQ Û& DQG
Û&
If the battery is inserted into the charger
when warm or hot, the CHARGING LED
indicator light on the charger may switch
on and illuminate RED. If this occurs allow
the battery to cool outside of the charger
for approximately 30 minutes.
CHARGER MOUNTING
1. This charger can be installed hanging on
a wall using two #8 screws (not supplied).
2. Locate the placement for the charger to be
wall mounted.
3. If fastening to wood studs use 2 wood
screws (not included).
4. Drill two holes on center 101.6mm apart
ensuring that they are vertically aligned.
5. If fastening to drywall use wall anchors(not
included) and screws to secure the charger
to the wall.
English (Original Instructions)
WARNING
IMPORTANT SAFETY INSTRUCTIONS
1. SAVE
THESE
DANGER: TO REDUCE RISK OF FIRE
OR ELECTRIC SHOCK CAREFULLY
FOLLOW THESE INSTRUCTIONS.
2. Confirm the voltage available at each
country location before using the charger.
3. If the sharp of the plug does not fit the
power outlet, use an attachment plug
adaptor of the proper configuration for the
power outlet.
CORRECT DISPOSAL OF THIS PRODUCT:
This marking indicates that this product should
not be disposed with other household wastes
throughout the EU. To prevent possible
harm to the environment or human health
from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse
of material resources. To return your used
device, please use the return and collection
systems or contact the retailer where the
product was purchased. They can take this
product for environmental safe recycling.
REMOVAL OF WASTE BATTERIES AND
ACCUMULATORS
Li-ion
Member
States
manufacturers design appliances in such a
way that waste batteries and accumulators
can be readily removed. Where they cannot
be readily removed by the end-user. Member
States shall ensure that manufacturers design
appliances in such a way that waste batteries
and accumulators can be readily removed by
TXDOL¿HG SURIHVVLRQDOV WKDW DUH LQGHSHQGHQW
of the manufacturer. Appliances in which
5
INSTRUCTIONS
shall
ensure
that
-
Publicidad
Tabla de contenido
