Chauvet DJ Bubble King Guía De Referencia Rápida página 4

B-550 Bubble King QRG
Mounting
AC Power
Fuse
Replacement
Setup
Fill/Replace
Bubble Fluid
Before mounting this product, read the Safety Notes. Place bubbler on a flat,
level surface or use the mounting brackets provided. Ensure that the bubbles
are not shooting directly in anyone's face or above heavy traffic areas, as
bubble fluid leaves a slippery surface. The bubble machine must not have
more than a 5° angle of inclination.
This product has a voltage-specific power supply that can work with an input
voltage of 120 VAC, 60 Hz or 230 VAC, 50 Hz.
To eliminate wear and improve its lifespan, during periods of non-use
completely disconnect from power via breaker or by unplugging it.
1. Disconnect the product from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the fuse holder out of the housing.
4. Remove the blown fuse from the holder.
5. Replace with a fuse of the exact same type and rating.
6. Insert the fuse holder back in place and reconnect power.
Install the sleeve to the front of the bubbler, using the 4 provided screws.
1. Place the Bubble King on a level surface and loosen the 4 thumb screws
on either side of the unit for fluid tank access.
2. Once removed, lift the cover.
3. Fill the tank with bubble fluid. DO NOT FILL PAST TOP OF FLUID
RESERVOIR.
Note: We recommend using CHAUVET bubble fluid (BJU or BJG)
which has been specially formulated for use with CHAUVET Bubble
King products. The tank capacity is 56 oz (1.7 l).
4. Lower the cover and tighten thumb screws.
4
EN