Light Kit Assembly; Important - Craftmade EVA54PR Guia De Instalacion

9. Light Kit Assembly.

Remove 1 screw from motor plate on underside of
motor and partially loosen the other 2 screws. Align
slotted holes in center of light kit fitter with loosened
screws in motor plate, allowing molex connections
from motor housing to come through hole in middle
of light kit fitter. Twist light kit fitter to lock. Re-insert
screw that was removed and secure all screws.
Push back sleeve on light kit wires with molex
connections to verify wire colors. Connect WHITE
wire from motor housing to WHITE wire from light
kit fitter. Connect BLACK wire from motor housing to
BLACK wire from light kit fitter. Be sure molex
connections snap together securely.
Carefully arrange wiring in opening in center of light
kit fitter.
Partially loosen the 3 screws on underside of light kit
fitter. Align slotted holes in threaded rod assembly
with loosened screws in light kit fitter. Twist threaded
rod assembly to lock.
IMPORTANT: Be careful when attaching threaded
rod assembly that the wiring does not get pinched or
caught under the metal edges. Allow wires to come
through corresponding openings in plate on
threaded rod assembly.
Use a Phillips screwdriver to secure all 3 screws on
threaded rod assembly.
Install 3 candelabra base 40 watt max. bulbs
(included).
Important: When replacing bulb(s), please allow
bulb(s) and shade to cool down before touching
them.
Remove finial and threaded washer from threaded
rod assembly. Align hole in center of shade with
threaded rod on threaded rod assembly and push up
gently until threaded rod comes through hole. Rotate
shade so straight edges on shade align with each of
the straight edges on border of light kit fitter. Secure
shade with the threaded washer that was previously
removed. Do NOT overtighten threaded washer as
shade may crack or break.
Align hole in center of shade cover with threaded rod
and push up gently until threaded rod comes
through hole. Rotate shade cover so straight edges
on shade cover align with each of the straight edges
on border of light kit fitter. Secure shade cover the
finial that was previously removed.
motor plate
threaded rod
assembly
threaded washer
page 8
motor housing
light kit fitter
molex
connections
bulb
shade
shade cover
finial