Canopy Assembly; Blade Assembly - Craftmade EVA54PR Guia De Instalacion

7. Canopy Assembly.

Locate 2 screws on underside of hanging bracket and
remove screw closest to the open end of the hanging
bracket. Partially loosen the other screw. Lift canopy to
hanging bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw that was
removed, and then tighten both screws securely. Slide
canopy cover up to canopy, aligning rounded part of
slotted holes in canopy cover with screw heads in
bottom of canopy. Turn canopy cover to the right
(clockwise) until it stops.

8. Blade Assembly.

Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate blade attachment screws and washers
in hardware pack. Hold blade arm up to blade
and align holes. Insert 3 blade attachment
screws (along with washers) with fingers first
and then tighten screws securely with Phillips
screwdriver. Repeat procedure for the
remaining blades.
Locate blade arm screws and lock washers in
hardware pack. Slide blade arm through one
of the rectangular openings on motor
housing, aligning blade arm holes with motor
screw holes and attach blade arm with lock
washers and blade arm screws. Before
securing screws permanently, repeat
procedure with remaining blade arms.
Securely tighten all screws.
Note: Tighten blade arm screws twice a year.
screw
motor housing
rectangular
openings
page 7
hanging bracket
canopy
screw
canopy cover
blade attachment
screws and washers
blade arm
lock washers
blade arm screws
blade