Publicidad
Idiomas disponibles
Idiomas disponibles
I I n n s s t t a a l l l l a a t t i i o o n n
Open the transmitter
and mount the base.
2
Do not change the position of the microswitches.
The positions were set at the factory in the position shown
in the following diagram.
1 : universal transmitter
2 : immediate triggering
3 : type of contact
(normally closed)
- Connect the 2 wires of
the sensor to terminals 1
and 2 of the technical
detector
- Leave the wired strap
between terminals 2
and 3.
- 15 -
3
1
ON
1 2
Transmitter
Strap
(do not remove)
Sensor
(not supplied)
P P o o w w e e r r s s u u p p p p l l y y
F F i i t t t t i i n n g g o o r r c c h h a a n n g g i i n n g g b b a a t t t t e e r r i i e e s s
- Remove the battery cover.
- If the batteries need replacing, fit 2 new LR03 type (or AAA)
alkaline batteries, same source and same date, ensuring
that the polarities are correct.
3
- Close the cover.
Never throw away flat batteries. They must be taken back to
the point of purchase.
F F l l a a t t b b a a t t t t e e r r y y i i n n d d i i c c a a t t i i o o n n
A series of 3 short beeps each time a radio message is
emitted.
2 piles
type LR03
(ou AAA)
The technical detector
must emit 2 beeps,
otherwise check the
battery polarities.
- 16 -
Publicidad
