Stopping the Engine
Ordinary Stop
•
Move throttle lever (A) to SLOW position.
•
Lower the engine speed to the idle speed. Keep
running at the idle speed for about one minute.
CAUTION
Engine damage can occur from run-on or
after-burning if engine is stopped suddenly
from high speed loaded operation. Reduce
engine speed to idle for one minute before
shutting engine off.
•
Turn the engine switch or the switch key to "OFF"
position.
For Control Panel Switch Type, move the throttle
lever against its low speed end to turn the ignition
off.
Emergency Stop
•
Immediately turn the engine switch or the switch
key to "OFF" position.
STOPPING
•
Close the fuel valve on the equipment.
For Control Panel Switch Type, move the throttle
lever on the equipment to its low speed end. Moving
the lever to its low speed end turns ignition off.
Always remove Engine Key from switch
when leaving equipment unattended or
when equipment is not in use.
STOPPING
WARNING
23
21