Thermador VTI610D Instrucciones De Seguridad Importantes página 5

INSTALLATION
1. Hold the fan on the wall.
Note the direction of the air conduction.
2. Mark the 4 mounting boreholes.
At least one screw must be installed through a stud.
The wall plugs must be suitable for the brickwork.
3. Drill the 4 x / " l mounting boreholes.
1
4
Insert wall plugs and screw the fan to the wall.
4. Connect the pipe from the fan to the extractor hood and
feed to the outside.
5. Connect the fan to the extractor hood with an extension
cable if required.
Use the added connector.
Use the wire diagramm for connecting.
The additional cover on the plug must always be
attached and closed for safety reasons.
Not needed wires must be isolated, capped with
wire nuts and stored in a safe position.
PAGE 3