Operation - Ryobi RE180PL1 Manual Del Operador

WARNING:
Do not allow familiarity with tools to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear safety goggles or safety glasses with side
shields when operating power tools. Failure to do so
could result in objects being thrown into your eyes
resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this tool. The use
of attachments or accessories not recommended can
result in serious personal injury.
APPLICATIONS
You may use this tool for the purposes listed below:
 Rout grooves, carve designs, mortise door jambs, and
create joints in wood and wood products
 Cabinet making, routing counter tops, and finishing work
in wood and wood products
WARNING:
Do not use bits with undersized shanks. Undersized
shanks will not tighten properly and could be thrown from
the tool causing injury.
CAUTION:
To prevent damage to the spindle or spindle lock, always
allow motor to come to a complete stop before engaging
the spindle lock.
WARNING:
If you are changing a bit immediately after use, be careful
not to touch the collet nut, bit, or collet with your hands or
fingers. You will get burned because of the heat buildup
from cutting. Always use the wrench provided.

OPERATION

WARNING:
If the collet nut is not securely tightened, the bit may
detach during use, causing serious personal injury.
WARNING:
Bit continues to rotate after the router has been turned off.
To avoid injury, wait until the bit has come to a complete
stop before removing router from the workpiece.
WARNING
Do not use bits which are larger than 2-1/4 in. Never use
bits which are larger in diameter than the opening in the
router subbase. These situations could cause possible
loss of control or create other hazardous conditions that
could cause possible serious personal injury.
INSTALLING/REMOVING THE 1/4 0
ADAPTOR
See Figures 2 - 3.
The collet is machined to precision tolerances to fit bits with
1/2 in. diameter shanks. To use bits with 1/4 in. diameter
shanks, insert the 1/4 in. adaptor into the 1/2 in. collet.
 Unplug the router.
 Remove chip shield from router base by pushing two
sides together and removing from base.
 Depress spindle lock.
 Place the wrench provided through front of router base
onto collet nut and turn counterclockwise to loosen.
 Install adaptor once collet nut is loose.
 Tighten the collet nut securely by turning clockwise with
the wrench provided.
 Release spindle lock.
 Replace chip shield.
To remove the adaptor:
 Place the wrench provided through front of router base
onto collet nut and turn counterclockwise to loosen.
 Loosen the collet nut and remove the adaptor.
 Release the spindle lock.
COLLET
NUT
10
:
in.
COLLET
1/4 in.
ADAPTOR
Fig. 2