Operation - Ryobi P610 Manual Del Operador

WARNING:
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear safety goggles or safety glasses with side
shields when operating tools. Failure to do so could
result in objects being thrown into your eyes, resulting in
possible serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this tool. The use
of attachments or accessories not recommended can
result in serious personal injury.
APPLICATIONS
You may use this tool for the purposes listed below:
 Planing the edge of a wooden door or shelf
 Planing the edge of a piece of lumber
 Making rabbet cuts in wood
This product will accept Ryobi One+ 18 V lithium-ion
battery packs and Ryobi One+ 18 V nickel-cadmium battery
packs.
For complete charging instructions, refer to the Operator's
Manual for the battery packs and chargers listed in the
General Safety Rules.
TO INSTALL BATTERY PACK
See Figure 4.
 Place the lock-off button in the center position to lock
the switch.
 Place the battery pack in the tool. Align raised rib on
battery pack with the groove inside the tool.
 Slide the battery pack into the tool until the latches on
each side of the battery pack snap into place and battery
pack is secured in the tool before beginning operation.
CAUTION:
When placing battery pack in the tool, be sure raised rib
on battery pack aligns with the battery port of the planer
and latches into place properly. Improper installation
of the battery pack can cause damage to internal
components.

OPERATION

BATTERY
PACK
TO REMOVE BATTERY PACK
See Figure 4.
 Place the lock-off button in the center position to lock
the switch.
 Locate latches on side of battery pack and depress to
release battery pack from the tool.
 The battery pack will automatically disconnect when
buttons are depressed.
 Remove the battery pack from the tool.
9
LATCH
Fig. 4