Important; Canopy Assembly; Blade Assembly. Pgs - Craftmade Loris Guia De Instalacion

6. Wiring. (cont.)
[PLEASE NOTE: Wall and/or handheld remote
control must be used for fan to operate. If you do
not wish to use the wall control, please proceed to
Section 7 below to continue with fan installation.]
To install wall control, remove existing wall
switch. Wire one of the wall controls with wire
connectors provided as shown in diagram at right.
*Wrap each wire connector separately with
electrical tape as an extra safety measure. Gently
push wires and taped wire connectors into outlet
box.
Install one 12-volt battery (included) in wall
control.
IMPORTANT: Wall control will not function unless
battery is installed.
Since this fan comes with a halogen bulb, the
dimmer switch (labeled DIM and ON/OFF) has
been pre-set to the "ON" position (DIM). If you do
not wish to have dimming capability, please move
the switch to the "OFF" position (ON/OFF).
Select a faceplate (almond or white) and press
firmly onto front of wall control. Attach wall control
to outlet box and secure with screws from original
wall switch. Attach plate (included) to wall control
using 2 screws provided with the wall control.

7. Canopy Assembly.

Locate 2 screws on underside of hanging bracket and
remove screw closest to the open end of the hanging
bracket. Partially loosen the other screw. Lift canopy to
hanging bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw that was
removed and then tighten both screws securely. Slide
canopy cover up to canopy, aligning rounded part of
slotted holes in canopy cover with screw heads in
bottom of canopy. Turn canopy cover to the right
(clockwise) until it stops.
8. Blade Assembly.
Time Saver: Fiber washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 9 blade attachment screws (and fiber washers)
in hardware pack. Hold blade arm up to blade and
align holes. Insert 3 blade attachment screws (along
with fiber washers) with fingers first and then tighten
screws securely with a Phillips screwdriver. [Refer to
diagram 1.] Repeat for the remaining blades.
outlet box
green/ green/ green/
bare bare bare
ground ground ground
black (OUT to fan)
black
black
(TO POWER supply)
black
(AC IN from
breaker box)
12V battery
(wiring for wall control)
canopy
screw
blade arm
diagram 1
page 6
wall
control
- 1 1
- 2 2
green
ON/ DIM
OFF
hanging bracket
screw
canopy cover
blade attachment
screws and fiber washers
blade
dimmer
switch
face-
plate
plate