Master Forge GBT13039L Manual Del Usuario página 19

TROUBLESHOOTING
Problem
Irregular flame pattern,
flame does not run the full
length of burner
Flame is yellow or orange
Flame blow out
Flare-up
Persistent grease fire
Flashback (fire in burner
tube(s))
Inside of lid is peeling
(like paint peeling)
Possible Cause
1. Burner ports are clogged or blocked
1. New burner may have residual
manufacturing oils
2. Spider webs or insect nest in venturi
3. Food residue, grease, etc.
4. Poor alignment of valve to burner
venturi
1. High or gusting winds
2. Low on LP gas
3. Excess flow valve tripped; safety
device may have been activated
1. Grease buildup
2. Excess fat in meat
3. Excessive cooking temperature
1. Grease trapped by food buildup
around burner system
1. Burner and/or burner tubes are
blocked
1. The lid is stainless steel, not painted
2. The lid is coated/painted
Prevention/Cure
1. Clean burner ports
1. Burn grill for 15 minutes on
the lid closed
2. Clean ventur
3. Clean burner
4. Ensure burner venturi is properly engaged
with valve
1. Do not use grill in high winds
2. Replace LP gas tank
3. Refer to "Sudden drop in gas flow or
reduced flame height"
1. Remove and clean all grill parts per
"Cleaning and Care" instructions in the
owner's manual
2. Trim fat from meat before grilling
3. Adjust (lower) cooking temperature
1. Turn control knob to
2. Leave lid in closed position and let fire burn
out
3. After grill cools, remove and clean all parts
per "Cleaning and Care" instructions in the
owner's manual
1. Clean burner and/or burner tube
1. Baked on grease buildup has turned to
carbon and is flaking off, clean thoroughly
per "Cleaning and Care" instructions in the
owner's manual
2. This can be from baked on grease buildup,
that has turned into carbon and is flaking off.
3. Clean thoroughly, per "Cleaning and Care"
instructions in the owner's manual.
4. After cleaning, if you can see steel, please
call out Customer Care at 1-800-963-0211
Lowes.com/masterforge
19
(HIGH)
with
"OFF "
.
®