Technical Data; Machine Elements; Intended Use - Collomix Xo 20 NC Manual De Servicio Original

EN

Technical data

Rated voltage
Idle speed 1st gear
Idle speed 2nd gear
Speed under load, 1st gear
Speed under load, 2nd gear
Maximum paddle diameter
Paddle support
External thread of the agitator shaft
Max. mix amount
Weight without paddle, without battery
Recommended CAS battery

Intended use

The machine is intended for mixing liquid and powder
building materials such as paints, mortar, adhesives,
plaster and similar substances
that offers the right mixing effect should be used based
on the consistency of the material and the quantity of
material being mixed
kg/40 litres should not be exceeded per mixture.
The information in the technical data should be noted
when selecting the paddle type (diameter/mixing
effect). Selecting an unsuitable mixing effect or paddle
diameter can overload the machine/drives and conse-
quently lead to damage. Please note that a paddle with
a mixing effect from top to bottom puts a greater strain
on the power tool than vice versa.
Due to the high torque of the machine, it is not permit-
ted for use as a drill.
It is not permitted to use the machine to prepare
foodstuffs.
The machine is not suitable for mixing materials con-
taining graphite dust, brine or slurry. Mixing these
substances can destroy the machine.
The user is solely responsible for damage caused by
improper use.
Generally recognised accident prevention regulations
and enclosed safety instructions must be observed.
Xo 20
- 470 min
- 780 min
- 350 min
- 580 min
140 mm
HEXAFIX
- 40 litres
4.05 kg
18 V, 5.2 Ah
.
The appropriate paddle
.
The total quantity of max. 30

Machine elements

1 Unlocking mechanism for On/Off switch
NC
2 On/Off switch
18 V
3 Unlocking mechanism for battery
-1
4 Metal frame
-1
5 Handles
-1
6 Battery pack
-1
7 Rubber buffer
8 Gear selector
9 Agitator shaft
10 HEXAFIX coupling
5/8"
11 Paddle
12 Capacity indicator button
Device-Specific Safety Instructions
L
WARNING:
instructions, illustrations and technical data provided
with this power tool
information and the following instructions may result in
electric shock, fire and/or severe injuries.
Retain all safety information and instructions for the
future.
The term "power tool" used in the safety instructions
refers to mains-operated power tools (with mains lead)
and battery-operated power tools (without mains lead).
It is only possible to work with the device safely if
you read the operating instructions and the safety
instructions in full and strictly follow the instructions.
The machine may only be used by persons familiar
with the operating instructions and the applicable
regulations regarding occupational safety and accident
prevention.
L
In addition, the "General Safety Instructions"
enclosed must be followed.
• Do not operate the device in an environment with
a potentially explosive atmosphere. Do not mix any
highly flammable solvents or solvent-containing sub-
stances with a flash point below 21 C.
• Ensure that no liquid sprays onto the motor housing
and also avoid exposure to the rain – risk of electric
shock!
• Do not clean the device with water – risk of electric
shock!
• Always hold the device with both hands when work-
ing and ensure you have a secure footing.
• Prior to commissioning, check that the mixing stick is
seated firmly and that it runs perfectly true.
Read all safety information,
.
Failure to observe the safety