Charge Indications - Philips HQ6715/16 Manual De Instrucciones

ENGLISH
4
C
C
C
Warning
Please read these instructions before using the
appliance.
Only use the HQ600 powerplug and the
charging stand supplied to charge the shaver.
The powerplug transforms 100-240 volts to
12 volts
Make sure the HQ600 powerplug and the
charging stand do not get wet.
The shaver runs at a safe low voltage of 12
volts. It is watertight and can be cleaned
under the tap. Do not rinse with water hotter
than 80cC.
For the best shaving results, shaving emulsion
should be pumped up frequently.

Charge indications

As soon as you start charging the empty
shaver, the green pilot light will go on.
The red pilot light will blink when the
batteries are almost empty.
The red pilot light will blink a few times after
the shaver has been switched off.
Charging
Recharge, store and use the appliance at a
temperature between 5cC and 35cC.
The powerplug is suitable for mains voltages
ranging from 100 to 240V.