Charging With The Supply Unit; Charge Indications; Battery Low - Philips 3000 Serie Manual De Instrucciones

Charging with the supply unit

Charge indications

Battery low

=
Charging
Charging takes approx. 8 hours. A fully charged
shaver has a shaving time of up to 40 minutes.
Note: You cannot use the shaver while it is
charging.
Note: Depending on your shaving/styling behavior
and beard type, the operating time may vary over
time.
1 Make sure the shaver is switched off.
2 Put the small plug in the shaver and put the
supply unit in the wall socket.
- The charging light on the shaver indicates the
charging status (see 'Charge indications').
3 After charging, remove the supply unit from the
wall socket and pull the small plug out of the
shaver.
When the battery is almost empty, the charging
light starts to flash red.
When you switch off the shaver, the charging light
continues to flash red for a few seconds.
When the shaver is charging, the charging light
flashes green.
11
English