Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
SPECIFICATIONS
Installation Requirements
The drop down door microwave oven can be installed in a
standard or flush inset application.
Finish the edges of the opening. They may be visible when
the door is open.
For standard installations, face trim will overlap stiles and
rails. Refer to the chart.
For flush inset installations, a minimum
required on all sides. To ensure consistent reveals, each
corner of the opening must be exactly 90°.
If the drop down door microwave oven is installed above
or below a Wolf E series oven in a flush inset application, a
1
/
"
reveal is required.
(6)
4
INSTALLATION REQUIREMENTS
BASE SUPPORT
Drop Down Door Microwave
TRIM OVERLAP
Top
Bottom
Sides
|
4
Wolf Customer Care 800.222.7820
1
/
"
reveal is
(3)
8
MIN
125 lb
(57 kg)
24" MODEL
30" MODEL
3
3
/
"
/
"
(5)
(5)
16
16
0"
0"
(0)
(0)
11
/
"
3
7
/
"
(18)
(98)
16
8
Electrical
Installation must comply with all applicable electrical codes.
Locate the electrical supply as shown in the illustrations on
the following pages. The receptacle may also be located
in an adjacent cabinet within reach of the power cord. A
separate circuit, servicing only this appliance is required. A
ground fault circuit interrupter (GFCI) is not recommended
and may cause interruption of operation. Refer to the illus-
tration below for minimum power cord plug clearance.
WARNING
ELECTRICAL SHOCK HAZARD: Plug into a grounded
3-prong outlet. Do not remove ground prong. Do not
use an adapter. Failure to follow these instructions can
result in electric shock, fire or death.
ELECTRICAL REQUIREMENTS
Electrical Supply
Service
Receptacle
Power Cord
3"
(76)
MINIMUM CORD
CLEARANCE
Power cord clearance.
grounded, 120 VAC, 60 Hz
15 amp dedicated circuit
3-prong grounding-type
4'
(1.2 m)
RATING PLATE
Rating plate location.
Publicidad
Tabla de contenido
