Publicidad
Idiomas disponibles
Idiomas disponibles
6.
Draw end of bunch with brown, black/green and grey/green leads to right standing lights. Place electric bunch
below boot loading edge, passing by lock holder:
a) Disconnect 6-input side joint from standing lights and connect with suitable joint in electric bunch. Connect
remaining joint of electric bunch to standing lights.
Draw remaining end of bunch with 6-input joints to left standing lights:
7.
a) Disconnect 6-input side joint from standing lights and connect with suitable joint in electric bunch. Connect
remaining joint of electric bunch to standing lights.
8.
Place 6-input joint behind left side casing in boot.
Connect additional control set in vehicles with light installation control using 6-input connection built in bunch.
This connection is not used in vehicles without light installation and bridge connection shall not be disconnected.
Additional set for electric installation control
9.
Draw grey/white and grey leads to left standing lights. There is a 19-input plug connection next to door post:
a) Ease the connection and disconnect it, draw 3-input casing (grey/white and white leads) from 16-input plug
slat,
b) Open blue blockade of 3-input casing and take out grey/white lead (fog lights function) from container no.1.
Assemble grey/white lead with end to enclosed end casing (small) and connect it to suitable casing in electric
bunch (grey/white lead),
c) Assemble end of grey lead of electric bunch in free container no.1 of 3-input casing. Close blue blockade and
assemble casing in 16-input plug slag. Reassemble 19-input plug connection next to door post.
10.
Vehicles without reversing control system (APS):
white lead with brown casing will not be used. Place it at the rear of boot lining.
Enclosed red lead with brown casing will not be used.
Vehicles with reversing control system (APS):
11.
Connect white wire with brown plug with the included red wire with brown plug and supply it to the parking assist
controller at D column. Disconnect the 16-pin plug from the parking assist and release the safeguard. Remove the
power strip casing. Remove the plug terminal from chamber 5 and plug the red wire terminal in chamber 5. Mount
the power strip casing, close the safeguard and connect the 16-pin plug with the controller.
Trailer power supply:
12.
Refer to 13-pin version. 3-pin connector housing (red/blue, yellow, white/brown, white/brown cables) is provided
for expanded socket functions. Put this part of cable set behind the trim. To expand socket functions it is necessary
to order the following parts:
Function "current supply and earth"
Function "current supply, charge line and earth"
Secure the cable set with supplied cable ties, re-install all trims and other parts which were removed during
installation.
Connect the earth lead to the battery and check all vehicle functions with connected trailer or suitable testing
device.
article no. 014-199
part no. 014-169
part no. 015-069
Publicidad
