Publicidad
Idiomas disponibles
Idiomas disponibles
44 03 11 07/13 / 01.09 / VA
Packing list: 1 Connection bunch
1 Connection bunch casing
1 Red lead
Disconnect the earth lead from the battery.
1.
2.
Remove boot floor casing and boot loading edge casing. Remove both side casings by standing lights.
3.
In order to draw electric bunch, disassemble casing on vehicle side. It is located in boot floor, at left side of spare
wheel well (possibly disassemble level control driver).
Connect the cable set in the following way:
4.
a) Draw end of lead bunch with assembled connection socket through entrance described in point 3 from boot
outside and then forwards, through the opening in holder of connection socket, assemble fair-lead located on
electric bunch in operating unit in vehicle,
b) There are two different washers under the socket. One is used by side entrance of leads, the other - in axis
entrance.
Side entrance: used in permanent assembly of tow hook with closed socket holder and detached tow hook with
folded socket holder. In such event, remove overpass in casing of connection socket.
Note !!! Use washer under socket assigned to side entrance for folded socket holder. Remove the other washer
assigned for axis entrance (it will not be used).
Axis entrance: used in permanent assembly of tow hook with opened socket holder and detached tow hook
without folded socket holder.
Remove washer assigned for side entrance (it will not be used).
c) Socket is connected according to the following scheme:
7 pin
Function
Indicator left
Fog light
Earth
Indicator right
Tail light right
Stop light
Tail light left
13 pin
Function
Indicator left
Trailer fog light
Earth
Indicator right
Tail light right
Stop light
Tail light left
Reversing light
Trailer current supply
Charge line plus
Charge line earth
Not assigned
Earth (trailer)
5.
Connect black 3-input casing to micro switch-key on the side of socket:
a) Assemble connection socket with packing washer using enclosed screws and nuts on socket holder,
b) Carefully fasten washer in the appropriate way,
c) Fasten electric bunch in such a way that there are no sharp bends and no wear.
Electrical Set for Trailer Connection
Part no.:
Part no.:013-638
3 Screws M5X35
3 Spring washer
3 Nuts M5
Installation instruction
Contact description
Cable colour
1
(L)
black/white
2
(54-G)
grey
3
(31)
brown
4
(R)
black/green
5
(58-R)
grey/red
6
(54)
black/red
7
(58-L)
grey/black
Contact description
Cable colour
1
black/white
2
grey
3
brown
4
black/green
5
grey/red
6
black/red
7
grey/black
8
blue/red
9
red/blue 2,5mm
10
yellow 2,5mm
11
white/brown 2,5mm
12
13
white/brown 2,5mm
7-pin
Audi A6 Avant manufactured 04.98 -
Audi A6 Allroad Quatrro manufactured 05.00 -
13-pin Audi A6 Avant manufactured 04.98 -
Audi A6 Allroad Quatrro manufactured 05.00 -
1 Small end casing
1 Large end casing
2 Cable ties 300 mm
2
2
2
2
15 Cable ties 100 mm
1
2
6
7
3
5
4
Contact description in
7-pin socket
8
9
7
1
10
6
2
4
3
5
11
12
13
Contact description in
13-pin socket
Publicidad
